Call Us Today @ (608) 212-8580 or (715) 598-7511

Vehicle Lifts

Harmar Inside Auto Lifts/Hoists

Harmar Inside Lift

Operation Difficulty: Moderate+

Inside Lifts are mounted in the vehicle’s cargo area with a hoist mechanism that swings outside the vehicle to load and lift the mobility device into the vehicle.

The operator of an Inside Lift should have the following capabilities:

  • Walk from the front to the rear of the vehicle and back
  • Stand for up to three minutes while the lift operates
  • Attach docking device to mobility device
    – May require bending over or kneeling
    – May require adequate hand dexterity
    – May require balance and strength to attach the docking device
  • Fold down the seat back of the mobility device and/or scooter tiller until it is in its most compact position
  • Apply pressure to hold down a button on the handheld control while lift operates
  • Guide the mobility device to avoid interference while raising, rotating, and entering the vehicle through complete lift cycle

Harmar Outside Lifts

Harmar Outside Lift

Operation Difficulty: Easiest.

An Outside Auto Lift is attached to the vehicle by means of a hitch and consists of an actuator and platform which secures and carries the mobility device on the back of the vehicle.

The operator of an Outside Lift should have the following capabilities:

  • Walk from front to rear of the vehicle and back
  • Stand for two to three minutes while the lift operates
  • Drive or push the mobility device on/off the platform
  • Insert the key and rotate it 90 degrees to turn on and activate the lift
  • Apply pressure to hold the up/down toggle switch while the lift operates
  • For models requiring securement with retractors, connect hook to location on mobility device. Pull strap end or turn knob to increase tension (single and dual-hand retractors available).

Harmar Hybrid Auto Lifts

Harmar Hybrid Lift

Operation Difficulty: Easy to Moderate.

Hybrid Lifts are mounted in the vehicle’s cargo area but are designed to move out and down so that the mobility device is loaded onto the platform on the ground. It is then lifted automatically into the vehicle for transport.

The operator of a Hybrid Lift should have the following capabilities:

  • Walk from the front to the rear of the vehicle and back
  • Stand for up to three minutes while the lift operates
  • Drive or push the mobility device on/off the platform
  • Fold down the seat back of the mobility device and/or scooter tiller until it is in its most compact position
  • Apply pressure to hold down a button on the handheld control while the lift operates
  • For models requiring securement with tie-down straps, connect hook to location on mobility device. Pull strap end to increase tension. Self retracting straps upgrade available.

We Have Hundreds of Mobility Products to Meet your Needs! Inquire Below!

Product Inquiry

  • This field is for validation purposes and should be left unchanged.
All Star Mobility, LLC